IP addresses are NOT logged in this forum so there's no point asking. Please note that this forum is full of homophobes, racists, lunatics, schizophrenics & absolute nut jobs with a smattering of geniuses, Chinese chauvinists, Moderate Muslims and last but not least a couple of "know-it-alls" constantly sprouting their dubious wisdom. If you believe that content generated by unsavory characters might cause you offense PLEASE LEAVE NOW! Sammyboy Admin and Staff are not responsible for your hurt feelings should you choose to read any of the content here.
The OTHER forum is HERE so please stop asking.

EDMWer asks Any difference between "fit to screen" and "stretch"? and gets a good reply from another EDMWer

Thread starter UltimaOnline
Start date Sep 18, 2025

Fit to screen is enlarge x (width) and y (height) pixels at at same ratio until 1 of the axis reaches the limit of your display.

Stretch is dun care about the ratio, just enlarge both axis until both reach the limit of your display.

Eg a perfectly square picture fit to a wide screen, will result in the largest square you screen can show. With empty areas on the left and right of the screen.

The same square stretched will fill your monitor entirely without any empty areas. But you'll end up with a rectangle.