seem like now got so many different un standardlise answers.
It can be done in minutes? U are full of shit.
seem like now got so many different un standardlise answers.
You ever said you are a car workshop owner. Memory lost?![]()
cut short story.
my car engine oil is leaking slowly.
fresh from servicing is 5 liter full.
3 month later, i check the dip stick,it show half full.
bending down and check, yes there are tiny drop of black oil dripping (should be very slow)
qns:
is it ok to buy another 2 liter to top it up?
i not too sure the previous serving the workshop use which synthetic oil.
can i just buy 5w50 and pour it in to mix it?![]()
you have a workshop?![]()
You ever said you employed a female clerk who is married and asked some questions on...Your posts can be digged out by googling.
You ever said you are a car workshop owner. Memory lost?![]()
"The best thing to do is just get a bottle of liquid gasket sealer and add it to your engine oil at the next oil change. that should stop the leaks"
Sure boh?? Sounds like pouring superglue into his engine.
he is not only FULL of shit.
He don't even know what a gasket looks like, the different sort of gasket, how to make gasket without an OEM gasket, where are gasket being used and not all gasket are the same.
In fact he might not even know that a car has an engine to power it! LoL
You dunno TS is SBF resident cheapo charlie wet market ah soh?
Best if you can find him a $2 solution because that's his budget.
Cb irresponsible cheap fucks like him not only endanger himself but other road users.
Save by cheating on parking coupons instead....at least no impact to others.
watch out for viscosity of oil, should get correct viscosity for your engine type. Otherwise, too low, loss or power....... too high viscosity...if I remember correct, may cause engine knocking.
Also if leaking because of your gasket; If oil mix with water in water jacket, radiator water oily. And any black smoke? If black smoke, then your piston ring may be worn. If not, then leakage at oil sump, and not at engine body or piston ring.
My 2c:(
If in doubt, flush and pour new oil.![]()
i did it on an older model acura tl for under 55 mins. the liquid gasket sealer only stalled the leak for 2 weeks. after fixing it i sold the car to a university couple. where i am we learn how to fix our own cars. one of the most difficult tasks is diagnosing issues with the catalytic converter, sensors, valves and plumbing when an old car doesn't pass smog test.
seem like now got so many different un standardlise answers.
Topping up is just short term, if car got many years to drive, better sent it for repairs, as engine seizure will cost even more, with a busted gasket.
If only left a few months to scrap, either sell it or just top up oil and tahan till scrap.
Crankshaft and camshaft distorted can cause oil leak?
What sort of shit are you talking and there is one fourmer who even says what you post is informative!
The kind of ppl in this forum.
If you had said the mating surface of the engine cases are damaged or the O ring/gasket and seal are worn/wrong sized or too compressed at least I will say you can post some sense.
Or it could even be the Ah Beng mechanic who did not torque the engine cases with a proper torque wrench with the correct torque!
Crankshaft and camshaft distort?LoL
d
stop piling on the bullshit. U have already been exposed. U said a gasket can be changed in a matter of minutes. 55 mins is not a matter of minutes. Its closer to one hour. And the shop rate for any mechanics in your neck of the woods for a gasket replacement should be around 3 hours. So, u are either the world's greatest mechanic or u are a big bullshitter.