• IP addresses are NOT logged in this forum so there's no point asking. Please note that this forum is full of homophobes, racists, lunatics, schizophrenics & absolute nut jobs with a smattering of geniuses, Chinese chauvinists, Moderate Muslims and last but not least a couple of "know-it-alls" constantly sprouting their dubious wisdom. If you believe that content generated by unsavory characters might cause you offense PLEASE LEAVE NOW! Sammyboy Admin and Staff are not responsible for your hurt feelings should you choose to read any of the content here.

    The OTHER forum is HERE so please stop asking.

Giant leap for Pi-powered teddy bear

Eldorado

Alfrescian (Inf)
Asset
Joined
Nov 15, 2012
Messages
283
Points
0

26 August 2013 Last updated at 16:54 GMT

Giant leap for Pi-powered teddy bear

_69490832_babbageimage.jpg


Babbage the bear snapped stills during its ascent

A soft toy controlled by a Raspberry Pi computer has re-created Felix Baumgartner's record-breaking skydive.

Mr Baumgartner made the highest ever freefall in October 2012 when he jumped from a balloon about 39km up.

A bear called Babbage has now leapt from a similar height after ascending beneath a hydrogen-filled balloon.

The Raspberry Pi low-cost micro-computer inside Babbage transmitted his position and shot stills and video throughout the flight and descent.

Sky high

The robot Babbage was created by high altitude ballooning enthusiast Dave Akerman, who has used the Pi as the control centre on other flights.

Babbage the bear is the official mascot of the Raspberry Pi project. The bare-bones computer was created to serve as an introduction to computers for children, but it has become a favourite among hobbyists who use it to control their home-brewed tech projects.

The Babbage flight is one of the more ambitious projects centred on the Pi and shows what the low cost computer can do.

The launch site was a field near Mr Akerman's home north of Newbury, Berkshire.

Take off was at 12:25 GMT on 26 August. Babbage drifted south west during his flight and rose to a height of just over 39km - slightly higher than Mr Baumgartner's record of 38,969m.

Mr Akerman made a cradle that Babbage sat on during the flight that was equipped with another camera that shot images similar to those taken over the shoulder of Mr Baumgartner before he jumped.

The Raspberry Pi inside the bear and his cradle switched from stills to video to record the moment when the toy fell off the cradle and started its descent.

On the Babbage flight, the Pi inside the bear's body logged altitude, shot footage and transmitted it back to the ground. It also constantly broadcast the craft's location so the flight could be mapped and the pioneering toy retrieved. Many people followed the flight online via the streaming video feed sent back by Babbage.

Mr Akerman said the whole flight had gone "brilliantly".

"It released on time at just above 39km," he told the BBC, adding that a firing mechanism on the balloon was set to triggered just above that altitude. "Now," he said, "we just need to get all the bits back."

Babbage landed around 16:00 GMT in a field a couple of few miles south of Shaftesbury. During his descent, Babbage was pursued by Mr Akerman and helpers in a chase car add was found around 17:26 GMT.

 
Back
Top